Corner clamp
Product details
- Economical alternative for fixed 90° angle for miter or butt joints
- Mounting holes to fix to work surface
- Adjusts to various sized work pieces with 2 spindles
- For light duty clamping
= Spare parts available
| Order number | Range of Angle | Clamping capacity | Approx. weight |
| ° | inches | lbs | |
|---|---|---|---|
|
WS-1
|
90 | up to 3" per side | 0.49 |
- Furniture and joinery works
- Interior fittings
- DIY
- Use the product only in its original condition.
- Use the product only for its intended purpose. Improper use can cause personal injury or property damage.
- Wear safety goggles to protect your eyes.
- Wear protective gloves to protect your hands.
- Wear safety footwear to protect your feet.
- The handle must always be free of oil and grease to prevent slipping.
- Keep the product out of reach of children.
- Small parts must not be swallowed or inserted into body openings.
- Check the product for damage before each use and make sure that all moving parts are working properly.
- A damaged product must not be used.
- Follow the care instructions for each product – see www.bessey.de.
- Use only original BESSEY spare parts.
- The Clamping tool must not be used for lifting, pulling or leaning.
- The clamping tool must not be used to secure cargo during transportation.
- The clamping tool may only be tightened by hand without any additional aids.
- The clamping tool must not be used for permanent installation.
- Regularly check that the end stop is working properly when using clamps.
- Upper and lower section made of zinc die-cast, powder-coated
- Spindle with trapezoidal thread in rolled steel, galvanised
- Handle made of wood, water-based paint
- Clean the rails using a suitable solvent to remove dirt and debris.
- Clean and oil the spindle regularly.
- Clean in regular cycles, depending on the degree of soiling.