Horizontal table clamp fixture, WNS20‑MFT‑SET
Product details
- Can be used on multifunction tables with a hole diameter of 20 mm with a plate thickness minimum of 19 mm
- Cam-action levers and rubber-padded clamp surfaces enable easy locking and quick release for a secure grip on your material, regardless of shape
= Show Spareparts
| Order number | Bolt | Clamping force | Approx. weight | Table thickness |
| mm | lbs | lbs | mm | |
|---|---|---|---|---|
|
WNS20-MFT-SET
|
20 | 170 | 2.89 | 19 mm (≥) |
Patented Low profile design
The patented pull-down mechanism prevents the work piece from lifting off the table – no fastening screws are required.
Secure work pieces
Hold work pieces on a 20 mm hole grid system. For use on multifunction tables such as Festool MFT and Sortimo WorkMo.
Quick clamping
Apply up to 165 lbs of clamping pressure using the side clamping lever.
Hold odd shaped work pieces
Round and flat work pieces are easy to position and hold thanks to cam-action side lever and rubber pads that enable easy locking and quick release for a secure grip.
- Furniture and joinery works
- Interior fittings
- DIY
- For use on multifunctional tables
- Use the product only in its original condition.
- Use the product only for its intended purpose. Improper use can cause personal injury or property damage.
- Wear safety goggles to protect your eyes.
- Wear protective gloves to protect your hands.
- Wear safety footwear to protect your feet.
- The handle must always be free of oil and grease to prevent slipping.
- Keep the product out of reach of children.
- Small parts must not be swallowed or inserted into body openings.
- Check the product for damage before each use and make sure that all moving parts are working properly.
- A damaged product must not be used.
- Follow the care instructions for each product – see www.bessey.de.
- Use only original BESSEY spare parts.
- The Clamping tool must not be used for lifting, pulling or leaning.
- The clamping tool must not be used to secure cargo during transportation.
- The clamping tool may only be tightened by hand without any additional aids.
- The clamping tool must not be used for permanent installation.
- Regularly check that the end stop is working properly when using clamps.
- Upper and lower section made of reinforced PA6 plastic
- Rail made of hardened steel, burnished
- Lever made of reinforced PA6 plastic
- Connecting elements made of steel, galvanised or burnished
- Clean the rails using a suitable solvent to remove dirt and debris.
- Keep the rail free of contaminants such as grease, oil, dried glue, wax, and silicone-based release agents, as these can affect performance.
- Clean in regular cycles, depending on the degree of soiling.