One‑handed table clamps, EZR‑SET (2 per set)
Product details
- With special guide on the top section for grooves 12 x 6.5 mm to 12 x 8 mm
- Use with adapter on the bottom section and rotated top section for secure fastening of guide rails from Festool, Protool, Metabo, Makita, Hitachi/Hikoki, Dewalt, etc. and for clamping in profiles and on work benches
- Use with adapter on the top or bottom section for step-over clamping
- Clamping force up to 100 lbs
- Ergonomically shaped 2-part plastic handle with pump lever behind the rail
- Ergonomically shaped 2-part plastic handle with pump lever behind the rail
= Show Spareparts
| Order number | Clamping capacity | Throat depth | Content | Spreading capacity | Clamping force | Approx. weight |
| inches | inches | pc. | inches | lbs | lbs | |
|---|---|---|---|---|---|---|
|
EZR-SET
|
6 | 2 3/8 | 2 | 4 3/4 - 12 | 100 | 1.94 |
- Furniture and joinery works
- Kitchen construction and shop fitting
- Interior fittings
- DIY
- Use the product only in its original condition.
- Use the product only for its intended purpose. Improper use can cause personal injury or property damage.
- Wear safety goggles to protect your eyes.
- Wear protective gloves to protect your hands.
- Wear safety footwear to protect your feet.
- The handle must always be free of oil and grease to prevent slipping.
- Keep the product out of reach of children.
- Small parts must not be swallowed or inserted into body openings.
- Check the product for damage before each use and make sure that all moving parts are working properly.
- A damaged product must not be used.
- Follow the care instructions for each product – see www.bessey.de.
- Use only original BESSEY spare parts.
- The Clamping tool must not be used for lifting, pulling or leaning.
- The clamping tool must not be used to secure cargo during transportation.
- The clamping tool may only be tightened by hand without any additional aids.
- The clamping tool must not be used for permanent installation.
- Regularly check that the end stop is working properly when using clamps.
- Upper and lower section made of reinforced PA6 plastic
- Rail made of hardened steel, burnished
- Lever made of reinforced PA6 plastic
- Plastic protective cap helps prevent surface damage during use
- Regular maintenance is essential to ensure a secure hold and prevent the sliding arm from slipping.
- Clean the rails using a suitable solvent to remove dirt and debris.
- Keep the rail free of contaminants such as grease, oil, dried glue, wax, and silicone-based release agents, as these can affect performance.