Horizontal table clamp fixture, WNS20‑MFT‑SET
Order number | Bolt | Clamping force | Approx. weight | Table thickness |
mm | lbs | lbs | mm | |
---|---|---|---|---|
WNS20-MFT-SET
|
20 | 170 | 2.89 | 19 mm (≥) |
Patented Low profile design
The patented pull-down mechanism prevents the work piece from lifting off the table – no fastening screws are required.
Secure work pieces
Hold work pieces on a 20 mm hole grid system. For use on multifunction tables such as Festool MFT and Sortimo WorkMo.
Quick clamping
Apply up to 165 lbs of clamping pressure using the side clamping lever.
Hold odd shaped work pieces
Round and flat work pieces are easy to position and hold thanks to cam-action side lever and rubber pads that enable easy locking and quick release for a secure grip.
- Interior fittings
- DIY
- Furniture and joinery works
- For use on multifunctional tables
- Clamping tools are not suitable for lifting, pulling or transporting.
- Clamping tools may only be clamped manually without using any auxiliary tools.
- Improper use can cause personal injuries or material damage.
- Never change or modify clamping tools. Only use them in their original condition. Only use original‐spare parts if required.
- Upper and lower section made of reinforced PA6 plastic
- Rail made of hardened steel, burnished
- Lever made of reinforced PA6 plastic
- Connecting elements made of steel, galvanised or burnished
- Clean the rails Using a suitable solvent to remove dirt and debris
- Keep the rail free of contaminants Such as grease, oil, dried glue, wax, and silicone-based release agents, as these can affect performance
- Clean in regular cycles, depending on the degree of soiling