K Body Clamp (KRE)
Product details
- Secure clamping force up to 1700 lbs
- Designed to clamp at 90 degrees with very large clamping surfaces
- Ergonomic two component handle with 6 mm steel socket (for hex key)
- Operating jaw stays where you put it for easy set up
- Converts to spreading with no tools required
| Order number | Clamping capacity | Throat depth | Spreading capacity | Clamping force | Approx. weight |
| inches | inches | inches | lbs | lbs | |
|---|---|---|---|---|---|
|
KRE3512
|
12 | 3 3/4 | 10 1/2 - 15 5/16 | 1700 | 4.8 |
|
KRE3518
|
18 | 3 3/4 | 10 1/2 - 21 1/2 | 1700 | 5.44 |
|
KRE3524
|
24 | 3 3/4 | 10 1/2 - 28 3/4 | 1700 | 6.1 |
|
KRE3531
|
31 | 3 3/4 | 10 1/2 - 36 1/2 | 1700 | 6.9 |
|
KRE3540
|
40 | 3 3/4 | 10 1/2 - 44 1/2 | 1700 | 7.65 |
|
KRE3550
|
50 | 3 3/4 | 10 1/2 - 52 1/2 | 1700 | 8.55 |
|
KRE3560
|
60 | 3 3/4 | 10 1/2 - 63 3/8 | 1700 | 9.5 |
|
KRE3582
|
82 | 3 3/4 | 10 1/2 - 81 7/8 | 1700 | 11.7 |
|
KRE3598
|
98 | 3 3/4 | 10 1/2 - 101 1/2 | 1700 | 13.25 |
- Interior fittings
- DIY
- Furniture and joinery works
- Large-area clamping and spreading
- Clamping tools are not suitable for lifting, pulling or transporting.
- Clamping tools may only be clamped manually without using any auxiliary tools.
- Improper use can cause personal injuries or material damage.
- Never change or modify clamping tools. Only use them in their original condition. Only use original‐spare parts if required.
- Upper and lower section made of reinforced PA6 plastic with inserted sheet metal parts for reinforcement
- Hollow profile rail made of steel, cold-drawn, galvanised
- Spindle with trapezoidal thread in rolled steel, burnished
- Handle made of 2-component plastic
- Pressure plate made of steel, cold pressed, galvanised
- Protective caps made of plastic
- Regular maintenance is necessary - only then can a secure hold be guaranteed (no slipping of the sliding bracket)
- Clean the rails with solvent
- Always keep the rail free of grease, oil or dried glue, waxes and silicone-based release agents
- Clean the fluting on the rails with a steel brush
- Clean and oil the spindle regularly
- If the lower part slips, turn the grub screw a 1/4 turn further (TG, KRE, KREV only)
